HB0566sam001 94TH GENERAL ASSEMBLY

Sen. Terry Link

Filed: 4/22/2005

09400HB0566sam001 LRB094 05756 LCB 45396 a

AMENDMENT TO HOUSE BILL 566

AMENDMENT NO. ______. Amend House Bill 566 by replacing everything after the enacting clause with the following:

"Section 5. The Tool and Die Lien Act is amended by changing Sections 1 and 2 as follows:

(770 ILCS 105/1) (from Ch. 82, par. 351)

Sec. 1. Lien. Plastic or metal processors or persons conducting a plastic or metal processing business shall have a lien on the tools, dies, molds, jigs, fixtures, forms or patterns in their possession belonging to a customer, for the balance due them from such customer for plastic or metal processing work, and for all materials related to such work. The processor may retain possession of the tool, die, mold, jig, fixture, form or pattern until such balance is paid, subject only to a security interest properly perfected pursuant to Article 9 of the Uniform Commercial Code.

(Source: P.A. 85-381.)

(770 ILCS 105/2) (from Ch. 82, par. 352)

Sec. 2. Definitions. For purposes of this Act:

(A) The term "processor" means any individual or entity including, but not limited to, a tool or die maker, who contracted with, or uses a tool, die, mold, jig, fixture, form or pattern to manufacture, assemble, or otherwise make a plastic or metal product or products for a customer.

(B) The term "customer" means any individual or entity who contracted with, or caused a plastic or metal processor to use a tool, die, mold, jig, fixture, form or pattern to manufacture, assemble, or otherwise make plastic or metal components or products.

(C) The term "special tool" means a tool, die, mold, jig, fixture, form, or pattern, or part used to manufacture, assemble, or otherwise make plastic or metal components or products.

(Source: P.A. 85-381.)".