Section 212.113  Incorporations by Reference

The following materials are incorporated by reference. These incorporations do not include any later amendments or editions.

a)         40 CFR part 60, Appendix A (1991):

1)         Method 1:  Sample and Velocity Traverses for Stationary Sources;

2)         Method 1A:  Sample and Velocity Traverses for Stationary Source with Small Stacks or Ducts;

3)         Method 2:  Determination of Stack Gas Velocity and Volumetric Flow Rate (Type S pitot tube);

4)         Method 2A:  Direct Measurement of Gas Volume Through Pipes and Small Ducts;

5)         Method 2C:  Determination of Stack Gas Velocity and Volumetric Flow Rate in Small Stacks or Ducts (Standard Pitot Tube);

6)         Method 2D:  Measurement of Gas Volumetric Flow Rates in Small Pipes and Ducts;

7)         Method 3:  Gas Analysis for Carbon Dioxide, Oxygen, Excess Air, and Dry Molecular Weight;

8)         Method 4:  Determination of Moisture Content in Stack Gases;

9)         Method 5:  Determination of Particulate Emissions From Stationary Sources;

10)         Method 5A:  Determination of Particulate Emissions From the Asphalt Processing and Asphalt Roofing Industry;

11)         Method 5D:  Determination of Particulate Matter Emissions From Positive Pressure Fabric Filters;

12)         Method 5E:  Determination of Particulate Emissions From the Wool Fiberglass Insulation Manufacturing Industry;

13)         Method 9:  Visual Determination of the Opacity of Emissions from Stationary Sources;

14)         Method 22:  Visual Determination of Fugitive Emissions from Material Sources and Smoke Emissions from Flares.

b)         40 CFR part 51 Appendix M (1994):

1)         Method 201:  Determination of PM-10 Emissions;

2)         Method 201A:  Determination of PM-10 Emissions (Constant Sampling Rate Procedure);

3)         Method 202:  Determination of Condensible Particulate Emissions from Stationary Sources.

c)         40 CFR 60.672(b), (c), (d) and (e) (1991).

d)         40 CFR 60.675(c) and (d) (1991).

e)         ASAE Standard 248.2, Section 9, Basis for Stating Drying Capacity of Batch and Continuous-Flow Grain Dryers, American Society of Agricultural Engineers, 2950 Niles Road, St. Joseph, MI 49085.

f)         U.S. Sieve Series, ASTM-E11, American Society of Testing Materials, 1916 Race Street, Philadelphia, PA 19103.

g)         Standard Methods for the Examination of Water and Wastewater, Section 209C, "Total Filtrable Residue Dried at 103-105~ C," 15th Edition, 1980, American Public Health Association, 1015 Fifteenth Street, N.W., Washington, D.C. 20005.

h)         "Guideline on the Identification and Use of Air Quality Data Affected by Exceptional Events," U.S. Environmental Protection Agency, Office of Air and Radiation, Office of Air Quality Planning and Standards Monitoring and Data Analysis Division, Research Triangle Park, N.C. 27711, EPA-450/4-86-007 July 1986.

i)          "Guideline on Air Quality Models (Revised)," U.S. Environmental Protection Agency, Office of Air Quality Planning and Standards, Research Triangle Park, N.C. 27711, EPA-450/2-78-027R July 1986.

j)          40 CFR 50, Appendix K (1992), "Interpretation of the National Ambient Air Quality Standard for Particulate Matter".

(Source:  Amended at 20 Ill. Reg. 7605, effective May 22, 1996)