TITLE 35: ENVIRONMENTAL PROTECTION
SUBTITLE B: AIR POLLUTION
CHAPTER I: POLLUTION CONTROL BOARD
SUBCHAPTER c: EMISSIONS STANDARDS AND LIMITATIONS FOR STATIONARY SOURCES
PART 215 ORGANIC MATERIAL EMISSION STANDARDS AND LIMITATIONS
SECTION 215.582 BULK GASOLINE TERMINALS


 

Section 215.582  Bulk Gasoline Terminals

 

a)         No person shall cause or allow the transfer of gasoline into any delivery vessel from any bulk gasoline terminal unless:

 

1)         The bulk gasoline terminal is equipped with a vapor control system that limits emission of volatile organic material to 80 mg/1 (0.00067 lbs/gal) of gasoline loaded;

 

2)         The vapor control system is operating and all vapors displaced in the loading of gasoline to the delivery vessel are vented only to the vapor control system;

 

3)         There is no liquid drainage from the loading device when it is not in use;

 

4)         All loading and vapor return lines are equipped with fittings which are vapor tight; and

 

5)         The delivery vessel displays the appropriate sticker pursuant to the requirements of Section 215.584(b) or (d); or, if the terminal is driver-loaded, the terminal owner or operator shall be deemed to be in compliance with this section when terminal access authorization is limited to those owners and/or operators of delivery vessels who have provided a current certification as required by Section 215.584(c)(3).

 

b)         Bulk gasoline terminals were required to take certain actions to achieve compliance which are summarized in Appendix C.

 

c)         The operator of a bulk gasoline terminal shall:  

 

1)         Operate the terminal vapor collection system and gasoline loading equipment in a manner that prevents:  

 

A)        Gauge pressure from exceeding 18 inches of water and vacuum from exceeding 6 inches of water as measured as close as possible to the vapor hose connection; and

 

B)        A reading equal to or greater than 100 percent of the lower explosive limit (LEL measured as propane) when tested in accordance with the procedure described in EPA 450/2-78-051 Appendix B; and

 

C)        Avoidable leaks of liquid during loading or unloading operations.

 

2)         Provide a pressure tap or equivalent on the terminal vapor collection system in order to allow the determination of compliance with 215.582(d)(1)(A); and

 

3)         Within 15 business days after discovery of the leak by the owner, operator, or the Agency repair and retest a vapor collection system which exceeds the limits of subsection (d)(1)(A) or (B).

 

(Source:  Amended at 14 Ill. Reg. 9173, effective May 23, 1990)