TITLE 35: ENVIRONMENTAL PROTECTION
SUBTITLE C: WATER POLLUTION
CHAPTER I: POLLUTION CONTROL BOARD
PART 307 SEWER DISCHARGE CRITERIA
SECTION 307.3807 LARGE-SIZED GENERAL MOLDED, EXTRUDED, AND FABRICATED RUBBER PLANTS


 

Section 307.3807  Large-Sized General Molded, Extruded, and Fabricated Rubber Plants

 

a)         Applicability.  This Section applies to discharges resulting from the production of molded, extruded, or fabricated rubber products, foam rubber backing, rubber cement-dipped goods, or retreaded tires by large-sized plants.  Specifically excluded from this Section are discharges resulting from the production of latex-based products and of tires and inner tubes, and discharges from textile plants subject to Subpart K.

 

b)         Specialized Definitions.  The Board incorporates by reference 40 CFR 428.71 (2003).  This incorporation includes no later amendments or editions.

 

c)         Existing Sources.  These sources must comply with the general and specific pretreatment requirements of Subpart B.

 

d)         New Sources

 

1)         The Board incorporates by reference 40 CFR 428.76 (2003).  This incorporation includes no later amendments or editions.

 

2)         No person subject to the pretreatment standards incorporated by reference in subsection (d)(1) may cause, threaten, or allow the discharge of any contaminant to a POTW in violation of those standards.

 

3)         "New source" means any building, structure, facility, or installation whose construction commenced after December 18, 1979.

 

(Source:  Amended at 47 Ill. Reg. 4662, effective March 23, 2023)