Section 808.111  Incorporations by Reference

a)         The Board incorporates the following materials by reference:

            ANSI.  Available from the American National Standards Institute, 1430 Broadway, New York, New York  10018, (212) 354-3300:

            ANSI/ASQC C1-1985, "Specification of General Requirements for a Quality Program", approved November, 1985.

            ANSI/ASQC S1-1987, "An Attribute Skip-Lot Sampling Program", approved March 6, 1987.

            ANSI/ASQC Q94-1987, "Quality Management and Quality System Elements – Guidelines", Approved June 15, 1987.

            ANSI/ASQC Z1.4-1981, "Sampling Procedures and Tables for Inspection by Attributes", Approved 1981.

            ANSI/ASQC Z1.9-1980, "Sampling Procedures and Tables for Inspection by Variables for Percent Nonconforming", Approved March 6, 1980.

            ASTM.  Available from American Society for Testing and Materials, 1916 Race Street, Philadelphia, PA  19103, (215) 299-5400:

            ASTM Standard D 3828-87 "Standard Test Methods for Flash Point of Liquids by Setaflash Closed Tester", approved December 14, 1987.

            ASTM Standard D-93-79 or D-93-80 "ASTM Standard Test Methods for Flash Point Pensky-Martens Closed Tester," approved August 19, 1980.

            ASTM Standard E 896-87 "Standard Test Method for Conducting Aqueous Direct Photolysis Tests", approved September 25, 1987.

            ASTM Standard E 1147-87 "Standard Test Method for Partition Coefficient (n-Octanol/Water) Estimation by Liquid Chromatography", approved February 27, 1987.

            ASTM Standard E 1148-87 "Standard Test Method for Measurements of Aqueous Solubility", approved April 3, 1987

            NTIS.  Available from the National Technical Information Service, 5285 Port Royal Road, Springfield, VA  22161, (703) 487-4600:

            "Methods for Chemical Analysis of Water and Wastes", Third Edition, March, 1983.  (Document number PB 84-128677)

            "Test Methods for Evaluating Solid Waste", Physical/Chemical Methods," EPA Publication number SW-846 United States Environmental Protection Agency (Third Edition, November, 1986).

            Federal Register.  Available from the Superintendent of Documents, United States Printing Office, Washington, DC 20402:  

            USEPA Guidelines for Carcinogenic Risk Assessment, 51 Fed. Reg. 33992-34003 (September 21, 1986).

b)         This Section incorporates no future amendments or editions.