Section 212.425  Emission Units in Certain Areas

a)         This Section shall apply to those emission units located in those areas defined in Section 212.324(a)(1) of this Part.

b)         No person shall cause or allow the emission of PM-10, other than that of fugitive particulate matter, into the atmosphere to exceed the following limits during any one hour period:

1)         57.2 mg/scm (0.025 gr/scf) for coater and cooling loop ventilator at a roofing asphalt manufacturing plant located in the Village of Summit;

2)         34.3 mg/scm (0.015 gr/scf) for mineral filler handling emission units at a roofing asphalt manufacturing plant located in the Village of Summit;

3)         0.03 kg/Mg (0.06 lb/T) of asphalt mixed for asphalt mixer at a roofing asphalt manufacturing plant located in the Village of Summit;

4)         91.6 mg/scm (0.04 gr/scf) for roofing asphalt blowing stills, except stills Nos. 1 and 2, at a roofing asphalt manufacturing plant located in the Village of Summit;

5)         45.8 mg/scm (0.02 gr/scf) for kilns in the lime manufacturing industry;

6)         22.9 mg/scm (0.01 gr/scf) for all other process emission units in the lime manufacturing industry;

7)         0.325 kg/Mg (0.65 lb/T) of glass produced for all glass melting furnaces.

c)         The mass emission limits contained in subsection (b) of this Section shall not apply to those emission units with no visible emissions other than fugitive particulate matter; however, if a stack test is performed, this subsection is not a defense to a finding of a violation of the mass emission limits contained in subsection (b) of this Section.

d)         The requirements of Section 212.324(f) and (g) of this Part shall also apply to this Section.

e)         Emission units shall comply with the emissions limitations and recordkeeping and reporting requirements of this Section by May 11, 1993, or upon initial start-up, whichever occurs later.

(Source:  Amended at 20 Ill. Reg. 7605, effective May 22, 1996)